Sunday, November 09, 2008

table lighting.

today, my dad and i made table lighting. we followed these instructions, with a few modifications. it's not competely right yet, the light is a little too yellow, as you'll see in the pictures. i'm going to get some different light bulbs, and something more transparent than the tracing paper i used.

what we used:

100watt energy save bulbs, tape, tracing paper, cross stitch board, dowel rods, and a lamp kit.and particle board. first, dad cut grooves into the particle board.

then we did as the instructions said and cut a hole in the board and inserted the light socket.

IMG_1349
but neither a regular bulb or a energy save bulb fit.

so dad modified.

IMG_1350
he made a little ledge to put the light socket on and then cut a hole so we could put the wire through the back.

IMG_1353
he then cut holes in the bottom for the dowel rods and and we slid them through. these are great, because you can lower the light if you need to.

IMG_1356
i then taped the tracing paper on the cross stitch board. the tape didn't hold it well enough, so i ended up stapling it to it.

IMG_1365
we taped white paper to the board behind the light so it wouldn't reflect the brown wood.

IMG_1373
here's what the finished product looks like. i slid the cross stitch board in the grooves and then taped it.

like i said, it's not perfect yet, i'm still going to make some modifications. but overall we spent about 15 bucks. which is much better than the 250+ you'd spend if you bought it already made.
i'm going to post some photos i took using it in a seperate post.


thanks for all the help dad, you're the greatest!




3 comments:

Note: Only a member of this blog may post a comment.